Pan lubing of cast bullets

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
Mauserbill
Full-Bore UK Supporter
Posts: 1205
Joined: Thu Jun 22, 2017 4:49 pm
Home club or Range: Range
Contact:

Re: Pan lubing of cast bullets

#11 Post by Mauserbill »

Hello
Been using Pyrodex and reduced smokeless loads.
I find the Pan lubing method very satisfying, as I like all the aspects of reloading the more complex the better, boring if you just went and bought ready assembled ammunition.
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests