Page 3 of 4
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 07, 2011 1:15 pm
by froggy
Re-
The 3 of them are all K31 ...
Here is were the photo & info comes from :
http://www.milsurpafterhours.com/bb/vie ... 46&start=0
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 07, 2011 1:27 pm
by AL8
The other two make my K31 look a bit tame, I wish I had the skills to make the middle one
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 07, 2011 1:52 pm
by froggy
Re-
I have been told those guys sell the stock for CHF 875.
http://www.richnerwaffen.ch/
It's a start ...
Re: What milsurp as a basis of a target rifle?
Posted: Sun Oct 09, 2011 3:19 pm
by meles meles
I generally like bullpups, but not that one. However, the middle stock is rather appealing. I wonder if an AICS system could also mount a K31 action?
Re: What milsurp as a basis of a target rifle?
Posted: Mon Oct 10, 2011 9:03 pm
by sandy22
Why not just get a native CG63?
Re: What milsurp as a basis of a target rifle?
Posted: Sat Oct 15, 2011 7:00 pm
by meles meles
I've tried: the last I tracked down in good condition was sold just a few hours before I could get my paws on it...
Re: What milsurp as a basis of a target rifle?
Posted: Tue Oct 18, 2011 8:16 pm
by dodgyrog
ovenpaa wrote:I would say 6,5x55 Swede, certainly a 1000 yard contender it would give you access to a fine range of good BC bullets without excessive recoil.
Target rifle, so you would be using open sights?
I wouldn't advise a Swede as it is a small ring action. The large ring on a 98 is far stronger for heavier loads.
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 28, 2011 6:44 pm
by meles meles
Small ring ?
Large ring ?
One ring to bind them all ?
*Baffled*
*Badgers have small brains....
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 28, 2011 6:56 pm
by dromia
The ring at the front of the reciever that the bolt lugs lock into.
Re: What milsurp as a basis of a target rifle?
Posted: Fri Oct 28, 2011 7:06 pm
by dodgyrog
Basally, on the small ring Mauser the thread on the barrel where it screws into the receiver is a smaller diameter than the large ring and is consequently weaker.
I've just bought a set of parts incl the barrel to fit a large ring Mauser. Currently in .308 it could easily become a 30-06. I got everything in the buy at the Trafalgar (except the receiver and I have one of those in hand).