Page 1 of 1
Front Sight for 308 BRNO
Posted: Sat Feb 15, 2014 3:16 pm
by 25Pdr
Hi,
Just bought a BRNO 308 from my favourite Dealer and it is screw cut for moderator. I've asked him to shorten the Barrel to 18" and since it still has the rear sight I've asked him to fit a front sight, I'm mainly going to use it with open sights.
He said that since the barrel is tapered the new sight will be higher up and this is causing him a problem.
Anybody know of a suitable sight that will do the job? The rear sight is non adjustable.
Re: Front Sight for 308 BRNO
Posted: Sat Mar 01, 2014 10:15 am
by ovenpaa
Did you manage to resolve this 25Pdr?
Re: Front Sight for 308 BRNO
Posted: Sat Mar 01, 2014 2:49 pm
by 25Pdr
Hi Ovenpaa,
Just picked the Gun up today.
The dealer wasn't too keen on fitting a front sight so I'll do something myself.
It wasn't a dear Rifle so I don't want to spend a lot on a fancy new sight, I just want open sights for close range fun with a Dromia Type cast Boolit load. razz
I've a clamp on Muzzle brake that I will drill and tap and install a home made front sight.
Cheers........Jim.
Re: Front Sight for 308 BRNO
Posted: Sat Mar 01, 2014 4:45 pm
by ovenpaa
A threaded pin filed to shape and blacked will probably do a cracking job.
Re: Front Sight for 308 BRNO
Posted: Sat Mar 01, 2014 5:03 pm
by 25Pdr
Thanks for that Ovenpaa....
Re: Front Sight for 308 BRNO
Posted: Sun Mar 02, 2014 5:17 am
by Dave 101
Re: Front Sight for 308 BRNO
Posted: Sun May 04, 2014 10:02 am
by Gundoc
Which model of BRNO is it?
I've had a offer of a BRNO CZ537- same model?
Re: Front Sight for 308 BRNO
Posted: Sun May 04, 2014 3:16 pm
by 25Pdr
Gundoc wrote:Which model of BRNO is it?
I've had a offer of a BRNO CZ537- same model?
Hi Gundoc..
It's a BRNO ZKK 601 308W
Got it for £175.00
Wanted to use it with open sights, considering cost of Rifle, Gunsmith charges for fitting a front sight not worth it.
So! A DIY job. I got a cheap muzzle break for a 10/22 from the States on EBAY, had to enlarge it to fit barrel with a Dremmel.
Drilled and tapped it for a sight made from a cut down screw as Ovenpaa suggested, added a Nylock nut and another screw behind it to provide a base for a sight hood I found, it just pushes on.
To keep it all in place I drilled and tapped two further holes in the side and drilled shallow holes in the barrel, two screws inserted and secured with Loctite, cut off the excess and ground smooth and painted.
