The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

So stupidly I was trying to reset the zero stop on my nightforce so i could perfect the zero for a new load.. Basically i undid the screws (that the manual specifically says not to do too much) to far, and the whole upper clutch part came away from the turret.. :cool2:

Has anyone here done something similar? Will i have to post it back to america or can someone sort it out here?

Seriously annoyed at myself, looks like my shooting plans are on hold for a few weeks (or however long it takes...)

RUAG are the NF importers, give them a ring

http://www.ruag.co.uk/contact-us

David TS wrote:RUAG are the NF importers, give them a ring

http://www.ruag.co.uk/contact-us

Great thanks, i'll give them a call

I did try emailing Nightforce, but got an auto responder from one of their reps saying they were out of office till may 5th. I was hoping it would be fixed by then!

Nightforce - like most of the US shooting industry - will be shut down while they are attending the NRA shooting extravaganza I guess.

RUAG ought to be able to help you.

Did speak to nightforce and as you say, they're away for the next couple of weeks.

Good shout on RUAG though, I've sent the scope to them and they are taking a look at it.

Hopefully get it resolved and I'll be more careful next time..