Page 1 of 2
Copper solvent
Posted: Sat Feb 10, 2018 9:57 pm
by Mauserbill
Anyone had any good results in the use of copper solvent in rifle bores.
I have been using No9 now for some time.
Range members claim various other products are better such as
Hoppes , Tipton, Tetra anyone got any conclusions regarding this issue.
Re: Copper solvent
Posted: Sat Feb 10, 2018 10:12 pm
by dromia
C2R.
Re: Copper solvent
Posted: Sat Feb 10, 2018 10:28 pm
by Alpha1
C2R What he said.
Re: Copper solvent
Posted: Sun Feb 11, 2018 12:04 am
by The Gun Pimp
For me it would be BoreTech Copper Remover, Sweets or Proshot Copper Remover.
Re: Copper solvent
Posted: Sun Feb 11, 2018 7:51 am
by Furiouspilgrim
If the bore is particularly bad, especially on a newly acquired gun, I’ll treat it to some dilute Amonia solution. Just have to be careful where you get it on the rest of the gun. You can even plug the barrel and leave it in for a couple of hours. It’ll sort out the copper and make the lead a lot easier to remove. Won’t harm the barrel. Just rinse it throughly afterwards.
Re: Copper solvent
Posted: Sun Feb 11, 2018 7:53 am
by ovenpaa
C2R for obvious reasons :)
Re: Copper solvent
Posted: Sun Feb 11, 2018 11:18 am
by ukrifleman
C2R is without a doubt, the best copper remover I have ever used.
ukrifleman
Re: Copper solvent
Posted: Sun Feb 11, 2018 1:20 pm
by Pete
Re: Copper solvent
Posted: Sun Feb 11, 2018 2:02 pm
by snayperskaya
Beat me to it.......this stuff is brilliant and also good if using corrosive Berdan-primed milsurp ammo that can be quite dirty.It can also be diluted with water so a little can go a long way.
Re: Copper solvent
Posted: Sun Feb 11, 2018 3:32 pm
by NoEntry
C2R for me. Best by far.
Mike