Page 1 of 1
Rossi Aiming advice
Posted: Sun Mar 25, 2018 5:52 pm
by Dahonis
Hi,
Rossi is shooting high 6-7" at 25 yards and was shooting right about 4".
I have tapped the rear sight and have got the POI sorted for windage.
Is there anywhere in the UK that does a taller front post for the Rossi please?
I only shoot Indoor at 25 yards so making sure my shots go where I need them for safety is a must.
Regards
Chris
Re: Rossi Aiming advice
Posted: Sun Mar 25, 2018 6:27 pm
by GeeRam
If anyone can, its likely to be A&A Gunsmiths.
http://www.aandagunsmiths.co.uk/
.
Re: Rossi Aiming advice
Posted: Sun Mar 25, 2018 6:30 pm
by TomH
Haven't seen a UK source, but there is one in Germany:
https://www.waffen-ferkinghoff.com/engl ... urus-rossi
Re: Rossi Aiming advice
Posted: Sun Mar 25, 2018 7:21 pm
by bradaz11
I bought a new front sight for my round barrel from here
https://store.stevesgunz.com/index.php? ... dc1af2mlq2
but because I bought a fibre one, can't use it for cowboy, so it never went on. think I bought the green
Re: Rossi Aiming advice
Posted: Mon Mar 26, 2018 5:25 am
by Dahonis
Thanks All, stevesgunz no longer ships to the uk
Re: Rossi Aiming advice
Posted: Mon Mar 26, 2018 6:23 pm
by bradaz11
which rossi do you have? would mine be any good to you>?
Re: Rossi Aiming advice
Posted: Mon Mar 26, 2018 7:28 pm
by GeeRam
Dahonis wrote:
Thanks All, stevesgunz no longer ships to the uk
Thats why I suggested contacting A&A, as they bring in all sorts of underlever bits from USA for modding Ubertis and Rossi's etc for cowboy action shooting.
Re: Rossi Aiming advice
Posted: Fri Mar 30, 2018 11:51 am
by Lancs_Oakley
I have 2 skinner tall and very tall front posts on the way from USA. I will probably only need one. PM me if you want the other. Not sure if it will fit though. Dovetail front post.
Re: Rossi Aiming advice
Posted: Fri Mar 30, 2018 2:31 pm
by ukrifleman
I had a similar problem at 50 yards with my Rossi M92 lever.
I removed the elevation ramp from the rear sight and it now shoots POA/POI.
ukrifleman
Re: Rossi Aiming advice
Posted: Wed Apr 04, 2018 12:40 pm
by hoppo
have similar problem with my Rossi 92.
I have the older front sight (part of the front barrel band)
I've lowered the rear as much as possible, still shoots 6inches high at 25yds.
I intend using the dremel to cut a higher front sight out of a suitable thickness washer,
Can anyone tell me roughly how much I need to increase the front sight height to lower the POI by 6inches at 25yds. I can obviously fine tune with a file at the range.
Thanks
Alan