Page 1 of 1
Stoeger M3K stock bolt thread?
Posted: Fri May 11, 2018 12:15 pm
by Gazza
Does anyone happen to know what thread the Stoeger M3K stock bolt is?
It verniers at 9.76mm/0.384" but is not M10.
I've included a picture with an M10 thread (bottom) for comparison.
The stock thread is noticeably finer than M10 so maybe imperial?
Re: Stoeger M3K stock bolt thread?
Posted: Fri May 11, 2018 1:41 pm
by Gazza
Addition:
The thread is 28 TPI
Re: Stoeger M3K stock bolt thread?
Posted: Fri May 11, 2018 2:39 pm
by glevum
I have seen 3/8 28tpi taps.
I think they were used on electrical fittings.
Stoeger is American so it is likely an Imperial thread
Re: Stoeger M3K stock bolt thread?
Posted: Fri May 11, 2018 2:43 pm
by Gazza
I have emailed Stoeger so lets see how good their technical department are
Re: Stoeger M3K stock bolt thread?
Posted: Sat May 12, 2018 12:08 am
by Gazza
I just got a reply back from MOA precision and apparently the thread is M10 1mm.
A quick gander on ebay brings a single bolt in at 8 quid
Re: Stoeger M3K stock bolt thread?
Posted: Sat May 12, 2018 6:03 am
by ovenpaa
I was about to say M10 fine :)
Will the bolt on ebay do the job?
Re: Stoeger M3K stock bolt thread?
Posted: Sat May 12, 2018 8:47 am
by Gazza
Ovenpaa wrote:I was about to say M10 fine :)
Will the bolt on ebay do the job?
Hopefully it will do the job Dave, yes.
I've ordered one so should be here Tuesday.
