PH Magazine spring

[M99]

I've managed to break the magazine spring in my PH 1200 magazine (noticed today that rounds were not feeding, stripped it down to find the spring had broken clean half way up)

So I am looking for a replacement, anyone know who makes magazine springs, as I doubt I will find a spring off the shelf?

Mike

[ovenpaa]

Norman Clark Gunsmiths has to be worth a try

[M99]

I've sent them an E-mail already (Being a Sunday, I doubted they would answer the phone!)

Mike

[Dave 101]

Hi Mike

I had a PH Scout with a square box mag 5 rnd it has a round wire spring , which I have spare if its any good to you .

Dave

[saddler]

Norman Clark Gunsmiths has to be worth a try

= as its similar to the 1st reply posted on the Stalking Directory...

[M99]

Hi Mike

I had a PH Scout with a square box mag 5 rnd it has a round wire spring , which I have spare if its any good to you .

Dave

Dave,

Many thanks - not sure it is the same, as mine has a flat spring.

I'll drop you a PM

Mike

[ovenpaa]

Norman Clark Gunsmiths has to be worth a try

= as its similar to the 1st reply posted on the Stalking Directory...

Hehe, I still beat you to the answer!

[Dave 101]

The overall length / height of the spring is 3 3/4" . the bottom coil is 3" middle coils 2 1/2 " the loading platform 2 7/8" x 3/4" at its widest point .

Dave

[M99]

Cheers Dave

Very different looking (Not withstanding that I have a flat spring) my magazine is one piece, without the removable base. So I am not sure the spring and magazine follower would fit.

Mike

[Dave 101]

Not looking to make anything out of it so for the price of the postage its yours , if you want to try it and see . Pass it forward as they say in the US .

Dave