The sensor fits to the scale using the existing screw holes above the damper blade, so, has anyone got a M1000 they could measure the distance between the screw holes please.
RCBS M1000 reloading scale?
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
RCBS M1000 reloading scale?
I've recently developed a dedicated Targetmaster sensor to fit the RCBS M500 scale - I have a sneaky suspicion that this will also fit the M1000 scale but don't have one available to measure.
The sensor fits to the scale using the existing screw holes above the damper blade, so, has anyone got a M1000 they could measure the distance between the screw holes please.
The sensor fits to the scale using the existing screw holes above the damper blade, so, has anyone got a M1000 they could measure the distance between the screw holes please.
Who is online
Users browsing this forum: No registered users and 4 guests